Daily Maintenance Of A Vacuum Sintering Oven

1. For the air pump with the function of Qi Town, you should check and open it for 30 minutes before the furnace is opened daily to remove the moisture in the pump oil.

2. Frequently check the stress of cooling water, compression air, hydraulic system, and the activity of cooling water.

3. The rubber sealing parts and flanges of the furnace door should be checked before the care door. There must be no sand grains and debris. Wipe the rubber sealing ring and flange noodles with a thousand net tiles, and then evenly apply it to the rear of the vacuum fat. Can be closed.

4. It is necessary to clean the workpiece before processing. After oil quenching, clean the soaked oil box and the oil on the carrier component.

5. Wind -cooling motors are generally commonly used motors. Under vacuum, it is not necessary to launch it to be inflated before it can be launched and should be maintained by electrical chain maintenance device.

6. The Ruz pump should be launched at a vacuum of more than 133Pa, and it should also be maintained by electrical link maintenance device.

In addition, the pipelines with compressed air should be opened with a watering valve every day. I often pay attention to whether the input and exit water temperature of cooling water indicates whether it is normal for the contact electrode joints, furnace doors, transformers cooling water pipes and other parts.